Operation mode analysis on a mobile phone during vibration alert

Nokia3

x

Reference coordinates and contour of the mobile phone.

 

 

 

x

 

This article describes the measurement and analysis of the operation deflection shapes and rigid body vibration motions of a mobile phone excited by its vibration alert. The mearurement is done, using a non contact, 3D, full-field, high speed stereo image correlation system in combination with the new Vic-3D FFT module analyzes the recorded deformation data in the frequency domain by phase-separation method.

Nokia

The measured deformations and displacements during the vibration alert are evaluated against the reference state for each stereo image pair. In this case the recording time covers about 5,5 seconds with 1000 FPS corresponding to about 5500 single measurements.

The following figure show the average vibration amplitude U.

 

Nokia2

Vibration Analysis of a Brake Disc

Bremsen1 Bremsen2
 x
Automobiles are subject to many forces using operation. Vibrations from the engine or the road-surface transmit through the vehicle’s chassis and suspension to the most essential mechanical component of the vehicle, the brake system.

Bremsen3

In this example, a 14” diameter brake disc from a heavyduty truck was excited using a small hammer to measure the vibration shapes of the rotor. The three-dimensional operational deflection shapes were easily identified and measured using the Vic-3D™ HS Vibration Analysis System. Amplitudes as small as 40 nanometers were measured at a frequency of approximately 2,000 Hz.